How To Add A Second Light Switch To An Existing Light Uk

Sunday, July 5, 2020

How To Add A Second Light Switch To An Existing Light Uk

Adding a light to a circuit. An end of run fixture is one that goes after the existing fixture in the circuit.

How To Wire A Double Light Switch Uk

Amazon Com Wemo Light Switch Wifi Enabled Works With Alexa And

Two Way Light Switching Light Fitting

Twist the wire nut onto the three wires to secure them.

How to add a second light switch to an existing light uk.

Replace the existing twin and earth cable between the ceiling rose and switch with a 3 core and earth type.
Unscrew the wire nut holding the two blue wires together on your existing light.
Replace the one gang switch with a two gang switch.

Installing a second switch for one light is a job that involves new 3 core and earth cable and new 3 way switches.
Unscrew the wire nut holding the two white wires together.
Actually i want to add an outside security light controlled by an internal light switch and while i am at it i want to run a lighting circuit in to the cellar and have a light and switch down there too i am currently working from a light plugged into a mains socket in the cellar and it isnt ideal as i need the.

If the existing cable is installed in conduit or a hollow wall it should be easy to pull a new cable in without damaging the wall.
Strip the last 25 cm 1 inch of your new blue wire and place all three blue wires together.
Choose a place for the fixture install an electrical box and run a cable between the new fixture and the existing one.

From there new 2 wire cable is run to the second new light box.
Make sure the cable you use is the same gauge as the one powering the existing fixture.
Unscrew the wire nut holding the two black wires together on your existing light.

Twist the wire nut onto the three wires to secure them.
If desired more lights can be added after that by running new cable to each new light box.
Run a length of 2 core earth 1mm or 15mm cable from the ceiling rose location to the switch.

At the existing light the hot and neutral wires are removed from the fixture terminals and spliced to the new cable wires running to the first new light.
Strip the last one inch of your new black wire and place all three black wires together.
You should do it only if you have some experience of working with electrical house wiring.

Decide on the location of the switch and mark out the position of the backox for the switch and cut out a channel in the wall from the location of the new switch to the ceiling.
Hello i wish to add a new light and switch to our existing lighting circuit.
Unscrew the wire nut holding the two brown wires together.